Installing Piaa 910's on the BMW K1200LT

I installed the Piaa 910's due to their high wattage (110) long distance view.  I welded tabs on the crash bars and cut slots in the plastic to slide over the brackets.   Rather than mounting the studs up as is normal, I mounted the lights with the studs aiming backwards.  This tucked the lights up very close to the plastic and made for a clean "factory look" installation.  When looking at the bike while standing, you can not see the brackets at all.  The switch is tied in to the high beam circuit.  The Piaa's only come on with the high beam, and if the remote switch is on.

 

Click on image to enlarge

Piaa6.jpg (54627 bytes) Finished Product
Piaa5.jpg (64538 bytes) Front View
Piaa4.jpg (65391 bytes) Plug Connector.  They are held on with "stick on" tie wrap fasteners
Piaa1.jpg (69083 bytes) Mounting Tab
Piaa2.jpg (71851 bytes) Rear View
Piaa3.jpg (72686 bytes) Location of  Remote Switch
Piaa7.jpg (87359 bytes) Relay location

Back to BMW K1200LT  Modification Page